What Else Can My Roofing Contractor in Illinois Do Besides Repairing and Replacing Shingles?

Who says pro roofers only focuses on repairing and replacing roofing materials? Found out more at : http://www.mainstreetgcinc.com

They are also skilled in other aspects that are closely related to the protection of living quarters and surrounding areas.

What’s more, they know very well that many homeowners want to get their hands dirty on tasks such as unblocking drains but won’t mind a little advice on this issue.

As a serious do it yourself fundi, you might want to get your hands dirty and stuck in sludge, but you need a little guidance in doing so. This is where roofers can provide practical advice to help you drain the affected area. Remember that in some parts of America it is considered illegal to do plumbing work yourself unless you are a certified plumber.

See the following guide if you can do it yourself:

  1. The first step, buy a plunger
  2. The second step, find the vent that overflows and cover it with a wet cloth. Make sure you close the second channel if you intend to work on the double sink. Bathrooms equipped with interconnected pipes must have all drains closed and ventilation areas. Also, make sure you apply Vaseline to the edge of your plunger, then fill your sink with enough water to cover your plunger head
  3. The third step is to plunge until the pressure finally forces the blockage to come out. Make sure you cover the entire channel with the plunger before starting to push it up and down. A good rule of thumb is to aim for at least 15 plunges or more before you stop. Don’t give up if you don’t succeed. Try again and again.
  4. Next, you need to pour a strong chemical drain cleaner for a small blockage. The contractor does not recommend that you do this for full obstructions because some chemicals are not suitable for specific equipment

If this does not work, then you should try the auger trap where you will remove the drain filter, then feed the auger wire inside the blocked drain. Make sure you continue to roll the handle while tightening and loosening the screw while the wire drops a little further into the sewer. When you hit something, is when you have to pull the wire back and forth after that you will gently release the auger wire, but do it slowly.

If there is still no luck, then you might want to try picking up a bucket to remove the cleaning plug located under your sink to catch water and debris that is likely to spill? Take a wire hanger to try and remove the immovable object. If you don’t succeed, you should try the auger trap once again, but this time you will feed it up.

If after all the trying and sweating you might find that your house is now flooded, and you desperately need a contractor to come to your rescue. They will use their water jetter and special camera drain equipment …

Roofing Companies Recommend the Use of Solar Hot Water Systems

Water heating systems powered by solar energy, and also called collectors, get fitted on the roof. These are installed on North facing roofs to ensure full optimization concerning the collection of heat from the sun that will heat up the water to be stored in hot water cylinders or boilers.

Seated inside of the collectors would be optimal ratio mixtures that consist of non-toxic antifreeze fluid to function as a heat transfer fluid to transport the heat inside the collectors into what they call heat exchanger coils for the tank.

Many a homeowner would love to change their electric geyser into a solar geyser and would approach a prominent roofing company to make their ideals a reality. Why is this the case? Because one of the biggest consumers within any household is your electric geyser as it uses as much as 40 to 45% of your power.

What You Need to Consider When Choosing a Solar System

  • Is my roof north facing?
  • If not, then west facing will also do. However, you’ll need additional panels to accommodate your tank size and compensate for the loss of sun energy in the morning.
  • Ensure there are no big trees that will throw shade onto the space that has been set aside for the installation of the solar panels on roof.
  • When selecting your solar powered tank, you should opt for a bigger one to maximize the power of the sun. Doing so will ensure that you would still have power during cloudy days.
  • Know those vertical tank systems are usually sized to set up as one centralized system per household. It features an insulated ring main system to feed hot water to all your designated water points.

The Orientation of the Solar Heat Collectors

The minimum suggested an angle of inclination for fitting flat plate collectors would be 10 degrees to ensure sufficient thermosyphon flow occurs, meaning that any rain will wash the dust of the glass materials.

The maximum angle of inclination should be set at 50 degrees. More significant angles will result in unwelcome shading during certain times of the year and result in less than desirable results.

Talking about shading, the solar collectors should be set up in such a way that they are shade free for the rest of the year. Shading should especially be avoided between 9am to 3pm. During this period, most of the solar energy is absorbed.

Partial shading during specific time slots of the day would have no effect on its efficiency as a solar panel.

In places where shading is unavoidable, you may want to request your roofing contractor to add extra collectors to compensate for the shortfall.

What if you choose to use gas water heaters instead of its electric counterparts?

There are numerous advantages to making use of gas water heaters, such as:

  • The water gets heated while it flows through your unit, and you can look forward to instant hot water.
  • These units are essentially low-pressure water heaters
  • Water