What Else Can My Roofing Contractor in Illinois Do Besides Repairing and Replacing Shingles?

Who says pro roofers only focuses on repairing and replacing roofing materials? Found out more at : http://www.mainstreetgcinc.com

They are also skilled in other aspects that are closely related to the protection of living quarters and surrounding areas.

What’s more, they know very well that many homeowners want to get their hands dirty on tasks such as unblocking drains but won’t mind a little advice on this issue.

As a serious do it yourself fundi, you might want to get your hands dirty and stuck in sludge, but you need a little guidance in doing so. This is where roofers can provide practical advice to help you drain the affected area. Remember that in some parts of America it is considered illegal to do plumbing work yourself unless you are a certified plumber.

See the following guide if you can do it yourself:

  1. The first step, buy a plunger
  2. The second step, find the vent that overflows and cover it with a wet cloth. Make sure you close the second channel if you intend to work on the double sink. Bathrooms equipped with interconnected pipes must have all drains closed and ventilation areas. Also, make sure you apply Vaseline to the edge of your plunger, then fill your sink with enough water to cover your plunger head
  3. The third step is to plunge until the pressure finally forces the blockage to come out. Make sure you cover the entire channel with the plunger before starting to push it up and down. A good rule of thumb is to aim for at least 15 plunges or more before you stop. Don’t give up if you don’t succeed. Try again and again.
  4. Next, you need to pour a strong chemical drain cleaner for a small blockage. The contractor does not recommend that you do this for full obstructions because some chemicals are not suitable for specific equipment

If this does not work, then you should try the auger trap where you will remove the drain filter, then feed the auger wire inside the blocked drain. Make sure you continue to roll the handle while tightening and loosening the screw while the wire drops a little further into the sewer. When you hit something, is when you have to pull the wire back and forth after that you will gently release the auger wire, but do it slowly.

If there is still no luck, then you might want to try picking up a bucket to remove the cleaning plug located under your sink to catch water and debris that is likely to spill? Take a wire hanger to try and remove the immovable object. If you don’t succeed, you should try the auger trap once again, but this time you will feed it up.

If after all the trying and sweating you might find that your house is now flooded, and you desperately need a contractor to come to your rescue. They will use their water jetter and special camera drain equipment so they can see what is causing the problem, and solve it.

There are four rules for cleaning sewers that have been blocked:

  1. Make sure you always wear high-quality rubber gloves that you can wash after the work is done and done. Also, you will handle the stem that goes far into the blockage.
  2. Don’t overthink about the smell you have to face.
  3. Stand away from the area as soon as you reach the stage where the sewer starts to empty itself.
  4. Make sure always to turn the rod in the same direction because you don’t want to open the drain due to an error.

An experienced subcontractor, hired by your preferred roofing company,  recommends rubber plungers to get rid of tangled willow roots because this is quite smooth and can be easily held by a steady hand.

Another thing is to calculate the distance from your channel cover to the road outside. Each rod is one yard long. Therefore, it is easy to know how far these lines need to be so they can penetrate the area. Continuously moving the rod will eventually remove the blockage. The key to being successful in your do-it-yourself endeavor is to be patient because the channel can take time to unblock.